|
|
|
|
|
|
|
Our recommended list of modules is below. Simply choose those you wish to purchase. |
||||||
  3 Way Linkwitz-Reilly active crossover with a number of useful features including variable x/o points, baff le-step and bass-boost. Each slope is separately controlled, so the x/o point can be pulled or squeezed to compensate for driver response. This low-noise, low-distortion circuit adds no unwanted artifact to the sound and can also be used as a gain-stage. Optional Phase-delay module fits on top of the crossover as shown. Also available without optional phase delay module
Also available as a plate-amp or monobloc project with power amps and power supplies Recommend -/+15v regulated power supply
|
||||||
 Regulated Pre Amp Supply for ZinAmp Solid State Phono and Pre Amps. Split rail supply, can be set to +/-21v, +/-15v and +/-12v DC. Requires an AC transformer with dual secondaries between 12v and 30v - min 20VA.
Ready-built PCB requires connectors to be purchased separately and soldered on. See datasheet for details.
|
||||||
 3 Way Linkwitz-Reilly active crossover with a number of useful features including variable x/o points, baff le-step and bass-boost. Each slope is separately controlled, so the x/o point can be pulled or squeezed to compensate for driver response. This low-noise, low-distortion circuit adds no unwanted artifact to the sound and can also be used as a gain-stage. Also available with optional phase delay module
Also available as a plate-amp or monobloc project with power amps and power supplies Recommend -/+15v regulated power supply
|
||||||
 Phase Shifter Module, for use with 3 Way Linkwitz-Reilly active crossover. Provides variable phase delay for two drivers in a 3-way setup - typically the mid-driver and the tweeter
|