|
|
|
|
|
|
|
Do you have your own enclosure or would you like one of ours? |
||||||||
  Stereo RIAA solid-state phono-amplifier of exceptional quality. Clear open sound, very low THD and sufficient current to drive a pre-amp and another line-level amplifier simultaniously. Utilises a split-rail power supply that provides exceptional linearity for enhanced dynamics and a tube-like warmth that is never fatiguing. Requires -/+12v to -/+15v power supply
Ready-built PCB requires connectors to be purchased separately and soldered on. See datasheet for details
|
||||||||
 Very low-noise stereo head-amp; adds moving-coil capability to ZinAmp's Valve Phono Amplifier. Amplifies the small-signal from a moving-coil phono cartridge to an amplitude suitable for a normal RIAA pre-amp. Selectable gain-levels and input-loadings for your particular MC cartridge.
Ready-built PCB requires connectors to be purchased separately and soldered on. See datasheet for details.
|
||||||||
 Reduces unwanted turntable and disc-surface noise by cross-feeding frequncies below 100Hz to mono.
Based on unique research, this filter achives a far superior 18dB/oct, where most other cross-feed filters only achive 6dB/oct and have to begin cross-feeding at a much higher frequency to achieve a similar effect. An 18dB filter is much less intrusive and leaves full stereo separation untouched, whilst adding no unwanted 'flanging' sounds or similar effects. Requires a split rail DC supply - recommended -15vDC and +15vDC.
|
||||||||
 Regulated Pre Amp Supply for ZinAmp Solid State Phono and Pre Amps. Split rail supply can be set supply to +/-21v, +/-15v and +/-12v DC. can be supplied from an AC transformer or other DC Supply - like a mains adaptor. This is a truely flexible supply.
Ready-built PCB requires connectors to be purchased separately and soldered on. See datasheet for details
|
||||||||
 Regulating Power Supply for use with external DC supplies like desk-top, wall-wart or laptop adaptors. Filters out noise and hash from these switch-mode supplies, providing very clean DC suitable for use with solid-state phono-stages and pre-amps. Designed to work with a 30vDC supply and provide a regulated split-rail voltage of -/+12v. These will power our solid state MM and MC phono modules as well as our active crossovers. Voltages can be changed with some component swaps.
Ready-built PCB requires connectors to be purchased separately and soldered on. See datasheet for details
|
||||||||
Heavy duty PCB with terminals for AC transformers and connections to power supplies. Terminals are provided for an AC fuse, On/Off switch and auto-power-off switch. Additional terminals for an AC relay and two thermistors form a "soft-start" feature that protects the on/off switch and other circuitry by limiting inrush current. Can be wired for 220v or 120v DC - see datasheet. Switch nets are snubbed to prevent switch-terminal arcing/pitting
Board layout conforms with CE Low Voltage Directive in that primary and secondary AC tracks are appropriately spaced. Pre-built PCB includes screw terminal blocks as standard. Please email us if you would like different connectors
|
